Repair, Maintenance & Calibration for Elebia Hooks and Clamps
This folder contains technical procedures for qualified service personnel, including: encoder and load cell calibration, component replacement (motors, gears, springs, latches), PCB reset, firmware versions, wiring diagrams, and troubleshooting for common issues (stuck lock pins, LED errors, latch malfunctions). These procedures require specialized knowledge and must only be performed by authorized technicians.
see VIDEO
Wed, 23 Jan, 2019 at 4:28 PM
The position encoder is the sensor that measures the position of the lifting clamp. All our automatic lifting clamps with position encoder are calibrat...
Mon, 26 Aug, 2019 at 3:17 PM
Understanding the Position Encoder and Calibration for Automatic Lifting Hooks The position encoder is a crucial component of our automatic lifting hook...
Mon, 16 Feb, 2026 at 11:21 AM
If there's a need to either replace, remove or add the evo2 lifting hook's lock pin cap, simply follow these instructions, and with the graphic cont...
Thu, 11 Jul, 2019 at 3:28 PM
Match the marks so the chain is aligned When both sprockets are in position, place the chain. Match again the mark of the main sprocket and place the chai...
Tue, 30 Jul, 2019 at 12:23 PM
evo5, evo10 and evo10c: see VIDEO
Wed, 23 Jan, 2019 at 4:30 PM
The behaviour of the evo automatic lifting hooks can be adjusted by modifying the values of the parameters. Many features can be adjusted (motor power, ...
Mon, 30 Sep, 2019 at 11:24 AM
The PCB of the evo automatic liting hook can be easily reseted. To do so, you must access the PCB where you'll find the reset button (red). In some...
Wed, 30 Jan, 2019 at 1:45 PM