Repair, Maintenance & Calibration for Elebia Hooks and Clamps
This folder contains technical procedures for qualified service personnel, including: encoder and load cell calibration, component replacement (motors, gears, springs, latches), PCB reset, firmware versions, wiring diagrams, and troubleshooting for common issues (stuck lock pins, LED errors, latch malfunctions). These procedures require specialized knowledge and must only be performed by authorized technicians.
How to Check If the Encoder Is Faulty Applies to: All current Elebia hook models (not applicable to early Evo5–Evo25 models, which use a timer-based sys...
Tue, 9 Jun, 2026 at 11:12 AM
Match the marks so the chain is aligned When both sprockets are in position, place the chain. Match again the mark of the main sprocket and place the chai...
Tue, 30 Jul, 2019 at 12:23 PM
Overview Replacing the motor on an Evo2 hook is a straightforward process, but it requires careful attention to detail to ensure everything functions prope...
Thu, 9 Apr, 2026 at 12:55 PM
Applies to: evo2, evo2L 1. Overview The PCB (Printed Circuit Board) is the "brain" of the Elebia evo2 hook. It controls all electronic functions...
Fri, 12 Jun, 2026 at 12:37 PM
Applies to: evo2, evo2L, evo5, evo10, evo20, evo25, S40 Overview The magnet sensor (also known as the auto-close sensor) is a critical component th...
Fri, 12 Jun, 2026 at 12:38 PM
Follow the instructions of the attached documents (DOCX. and/or PDF) in order to calibrate the load cell of the evo range of automatic lifting hooks. ...
Mon, 10 Feb, 2020 at 10:39 AM
evo5, evo10 and evo10c: see VIDEO
Wed, 23 Jan, 2019 at 4:30 PM
The behaviour of the evo automatic lifting hooks can be adjusted by modifying the values of the parameters. Many features can be adjusted (motor power, ...
Mon, 30 Sep, 2019 at 11:24 AM
Symptoms If you notice that the red LED on your Elebia hook is blinking while the hook is either fully open or fully closed, or if the LED unexpectedly cha...
Mon, 13 Apr, 2026 at 12:19 PM