The behaviour of the evo automatic lifting hooks can be adjusted by modifying the values of the parameters.
Many features can be adjusted (motor power, autoclose behaviour, electric brake, re-open or re-close conditions, radio setup, weighing scale setup, battery threshold, etc.)
Parameters must not be modified by non-qualified personnel. Misadjusments in the parameters can lead to failure and to the loss of the warranty.
The simplest way to modifying the hook's parameters is with the eMAX remote control. Thanks to its big display with menus and membrane keypad, it offers a simple and intuitive way to do it. Refer to the eMAX user manual for more info.
If you prefer to modify the hook's parameters with the eMINI or eINST remote controls, refer to the eMINI program mode at the end of this article.
Here you can find the table of parameters:
- evo2 neo20 and neo50 automatic lifting hook
- evo5 to evo25 automatic lifting hooks
eMini program mode:
To modify parameters using the eMINI remote control, you must:
- Make sure the automatic lifting hook you want to adjust is powered on, and any other hook is powered off.
- With the remote control (already linked to the hook), enter the program mode:
- press and hold firmly the 'mode' button until a '3' is displayed.
- while holding it, press the 'elebia' button 3 times, until a flashing 'b' is displayed. (You have 3 seconds to complete this procedure. After 3 seconds, it will display 'E' and abort the process.)
- To modify the level of the parameter, press the 'elebia' button as many times as necessary. (some parameters like frequency, require a long press to be modified, to avoid mistakes)
- To move to the next parameter, press 'mode' once.
- To exit the program mode, press and hold the 'mode' button for 5 seconds (or wait 5 seconds without touching any button).
- Once a flashing 'b' is displayed, you will have exited the program mode.
Some video examples: