The PCB of the evo automatic liting hook can be easily reseted.


To do so, you must access the PCB where you'll find the reset button (red).

In some PCB's there is no button, but reset pins or reset wires.


Press and hold the reset button for reset:


Partial reset:

Press and hold the reset button between 4 to 10 seconds. 

  • All parameters return to the default settings. 
  • Serial number and cycles are not erased.


Total reset:

Press and hold the rest button for more than 10 seconds:

  • All parameters return to the default settings.
  • Serial number and cycles are erased.

The reset button can also be used for:


Motor calibration:

2 short pulsations:

  • The automatic lifting hook will run the calibration process.


Program mode:

1 short pulsation:

  • The automatic lifting hook will access the program mode.
  • While in program mode, you can link the eMINI and eINST remote controls by pressing the 'mode button' (remotes must be set in 'one button mode'.)